ARCHIVED FORUM (READ-ONLY)  ·  about this archive
3DBatix Forum Index

Some foamie questions
2 posts
 
   3DBatix Forum Index -> 3D Talk
 
Author Message
ronerik



Joined: 30 Jan 2006
Posts: 8

PostPosted: Tue Jan 31, 2006 9:04 am    Post subject: Some foamie questions  

I have been flying for about 3 years now and recently moved to foamies. I was wanting to know about some set up questions. On the ESC, do you use a hard cutoff or a soft cutoff. I remember my heli was soft, but what do you use for a plane?

Why does my Mini Katana wanna roll to the left in a hover? I have right thrust on the motor mount. Set up is a Dualsky 300b motor with an APC 9x3.8 slofly prop. Someone said in another forum that a bigger prop would help. Is this correct?
Back to top  
rmgmag



Joined: 31 Jan 2006
Posts: 1

PostPosted: Tue Jan 31, 2006 12:01 pm    Post subject:  

From what I've been told, hard cut-off is for gliders where the prop needs to be stopped and folded back so there's less drag. For foamies go with a soft cut-off.

Just about every plane wants to roll left in a hover. It's a combination of the torque of the motor and the slipstream from the prop. A larger diameter prop will make the problem worse but it should generate more thrust. A small flat prop will help, but you won't have nearly as much thrust. Keeping the plane upright at either slightly more or less than 90 degrees to the ground will help, but you'll probably drift a bit more.

_________________
Bob
Get a free nutritional analysis at www.bobg.unfranchise.com
Back to top  
 
   3DBatix Forum Index -> 3D Talk All times are GMT - 8 Hours

Powered by phpBB 2.0.6 © 2001, 2002 phpBB Group

blueGray theme by Nuttzy
Restored from the Internet Archive, 2026 · about this archive