ARCHIVED FORUM (READ-ONLY)  ·  about this archive
3DBatix Forum Index

LiPo problems
14 posts
 
   3DBatix Forum Index -> Foamies
 
Author Message
Radioflyer



Joined: 14 Sep 2004
Posts: 344
Location: Kalamazoo, MI

PostPosted: Fri Jan 06, 2006 2:01 pm    Post subject: LiPo problems  

Hey, I'm new with the batteries and now I think I have a problem with them. I got two thunder Power 900 mah, 3c, 10c continuous 16c burst, also I'm useing a Castel 10 amp speed control. I've use them both regularlly from May to September, but let them sit, fully charge, until this month. In fact before I used them again I threw them on my Triton charger. They have very little power now. They start out well but then the power falls off and it's variable. They won't sustain a hover when before the plane was a rocket. I wondered if it was the speed control but I've noticed that the red led blinks when it's at full power, showing an overload but without changing the throttle postion it slows and then goes variable. Even without overloading the speed control the power just drops off. Both packs do this now. I did notice that the batteries were starting to do this before I got busy and couldn't fly. Both batteries have about 60 to 70 flights on them.Any suggestions?
_________________
God bless us all, and keep us safe.


www.bryanhusk.com/jay
Back to top  
Batix Kid



Joined: 07 Apr 2005
Posts: 90

PostPosted: Fri Jan 06, 2006 2:41 pm    Post subject:  

On average you would get about 100 flight out of a lipo (i think) it may just be the batteries have come to the end of there lives,are both batts doing the same?i wouldnt of thought it would be your esc because they just tend not to work at all if there damaged from my experence.
Hope this helps
Back to top  
Radioflyer



Joined: 14 Sep 2004
Posts: 344
Location: Kalamazoo, MI

PostPosted: Fri Jan 06, 2006 4:00 pm    Post subject:  

Yeh, both are doing it. I'm kind of disappointed, but the other hand I got quite alot of use out of them Very Happy
_________________
God bless us all, and keep us safe.


www.bryanhusk.com/jay
Back to top  
3dbatixkid
Moderator


Joined: 15 Apr 2004
Posts: 1178
Location: Sunnyvale, CA

PostPosted: Fri Jan 06, 2006 8:02 pm    Post subject:  

check the voltage of the packs after they have been charged. 3S should be about 12.6v. Also, try charging them at a slower rate, less than 1C. The Triton is a conservative charger too. If you have a different charger, try that as well.
_________________
Zak West

www.DesertAircraft.com

www.Smart-Fly.com

www.DarrolCady.com

www.CoolRunningUSA.com

www.TanicPacks.com
Back to top  
d



Joined: 18 Dec 2005
Posts: 9
Location: San Jose

PostPosted: Fri Jan 06, 2006 8:44 pm    Post subject:  

I've had 'em go weird on me when they sit for a while, then come back. Usually it takes a couple of cycles, and (like Zak already mentioned) a slower charge. I usually try about .5C.

On the other hand, sometimes they just die.

So far, my batts have been running between about 70 and 250 (!) or so cycles. I'll generally charge at about .8C and try to hold it to 10C or less discharge (except for the little Kokams, which I treat like dirt. And they still hold up!)


Dave North
Back to top  
Radioflyer



Joined: 14 Sep 2004
Posts: 344
Location: Kalamazoo, MI

PostPosted: Sat Jan 07, 2006 5:37 pm    Post subject:  

I don't have any other charger for LiPos. I am currently trying to discharge my#1 pack slowly at low throttle. I have cycle both packs now 4 times with no difference. The packs seem to get more power while I use them, (same cyle). They start out slow and get better Shocked This goes against everything I know about batteries. I figure one thing, Lipos work off of volts, not amps, because I'm just not getting the proper voltage out of them. When I check the Triton when the charge is finished it reads around 12.5 or more. It's like my batteries are constipated, you know it's there, it just won't come out What is the best charger for LiPos?
_________________
God bless us all, and keep us safe.


www.bryanhusk.com/jay
Back to top  
3dbatixkid
Moderator


Joined: 15 Apr 2004
Posts: 1178
Location: Sunnyvale, CA

PostPosted: Sat Jan 07, 2006 6:37 pm    Post subject:  

Lipos have an operating temp (sometimes). If the battery is cold, running it will heat it up internally and it will give you more power. The Astro 109 charger is very good, but pricey. A good inexpensive charger is the Thunderpower 425. It charges to 4.2v per cell, which is great. Nice charger to have.
_________________
Zak West

www.DesertAircraft.com

www.Smart-Fly.com

www.DarrolCady.com

www.CoolRunningUSA.com

www.TanicPacks.com
Back to top  
Joedaniwhite



Joined: 15 Jan 2005
Posts: 44
Location: Millbury, MA

PostPosted: Mon Jan 09, 2006 1:36 pm    Post subject: Lipos  

Hi there,

Zak hit it on the head. Check the voltage of each battery in the pack. My guess is that it is the center battery that's giving you fits. That poor guy doesn't get the cooling like the outboard cells. Try charging at a slower rate a couple times before junking the pack.

Also, most guys are not letting the batteries cool long enough before they stick them on the charger after a flight. I know because I did the same thing. You may be able to make a better pack by soldering good cells remaining in each old pack. Be careful not to short out the things!

These batteries don't seem to like temps below 50 degrees either. They are just not as efficient.

Joe
Back to top  
Radioflyer



Joined: 14 Sep 2004
Posts: 344
Location: Kalamazoo, MI

PostPosted: Mon Jan 09, 2006 4:03 pm    Post subject:  

I'm not having any luck reviving these packs. I store them inside at 70 degrees and haven't even tried to fly them outdoors. I think the cells got out of balance and they're not coming back. I'm going to see if I can use a friends 900's to see if they work. If they do I'll junk these two packs and never leave the future ones alone
_________________
God bless us all, and keep us safe.


www.bryanhusk.com/jay
Back to top  
Joedaniwhite



Joined: 15 Jan 2005
Posts: 44
Location: Millbury, MA

PostPosted: Mon Jan 09, 2006 5:00 pm    Post subject: There ya go!  

That's the way to do it!
Back to top  
beironxx



Joined: 02 Dec 2005
Posts: 4
Location: Slovenia

PostPosted: Tue Jan 31, 2006 3:49 am    Post subject:  

I did not see anyone mention using LIPO balancer like: http://aircraft-world.com/prod_datasheets/hp/eoslba6/eoslba6.htm

So do you use it or not? Because I have heard and read about problems with Lipo bateries.

What are your experiances with lipos?
Back to top  
3dbatixkid
Moderator


Joined: 15 Apr 2004
Posts: 1178
Location: Sunnyvale, CA

PostPosted: Tue Jan 31, 2006 9:04 pm    Post subject:  

A balancer is only good if the battery is half way to being toast. If a cell is dead, its dead, and a blancer isnt gonna do a whole lot. If you have discharged a battery at its full potential, or more, and now have an unbalanced pack, the blanacer can help keep that low cell from completely falling off the face of the earth.
_________________
Zak West

www.DesertAircraft.com

www.Smart-Fly.com

www.DarrolCady.com

www.CoolRunningUSA.com

www.TanicPacks.com
Back to top  
beironxx



Joined: 02 Dec 2005
Posts: 4
Location: Slovenia

PostPosted: Wed Feb 01, 2006 6:54 am    Post subject:  

Yes I agree but did you ask yourself why this happens? What is in most cases reason that one of 3 cell battery goes toast?

I think that mostly because different discharging, different cooling conditions (middle cell), etc...

My opinion is that life expectation if you use lipo balancer is significant prolonged.

So if I understand you do not use balancer?

_________________
Dejan
Back to top  
3dbatixkid
Moderator


Joined: 15 Apr 2004
Posts: 1178
Location: Sunnyvale, CA

PostPosted: Wed Feb 01, 2006 11:07 am    Post subject:  

You may be right, but the amount that the middle cell would be different is directly proportional to how hard the battery is abused. I do not use a balancer on my packs.
_________________
Zak West

www.DesertAircraft.com

www.Smart-Fly.com

www.DarrolCady.com

www.CoolRunningUSA.com

www.TanicPacks.com
Back to top  
 
   3DBatix Forum Index -> Foamies All times are GMT - 8 Hours

Powered by phpBB 2.0.6 © 2001, 2002 phpBB Group

blueGray theme by Nuttzy
Restored from the Internet Archive, 2026 · about this archive