ARCHIVED FORUM (READ-ONLY)  ·  about this archive
3DBatix Forum Index

FOAMeIIx control deflections
6 posts
 
   3DBatix Forum Index -> Foamies
 
Author Message
Glider_five_seven



Joined: 21 Nov 2005
Posts: 4

PostPosted: Wed Dec 07, 2005 1:24 pm    Post subject: FOAMeIIx control deflections  

I've just finished building My FOAMeIIx and I was wanting to know what control deflections and expo rates that people set.

This is my first foamie.



FoameIIx.JPG
 Description:
 Filesize:  48.56 KB
 Viewed:  370 Time(s)

FoameIIx.JPG


Back to top  
3dbatixkid
Moderator


Joined: 15 Apr 2004
Posts: 1178
Location: Sunnyvale, CA

PostPosted: Wed Dec 07, 2005 11:37 pm    Post subject:  

I dont know what your piloting skills are like on things other than foamies, so you will probably want to set up dual rates. I set my high rates for all the control throw i can get. On this plane i would run about 60-80% expo on all the surfaces. You can tune it in to your likes after you put a flight or two on it. For low rates, i would go 50% of your high rate, except on ailerons where you might want to do 40% or even as low as 30%. Then set all your expos for about 55-60%. This will give you a nice soft low rate, and also a high rate that is manageable. Hope this helps Surprised
_________________
Zak West

www.DesertAircraft.com

www.Smart-Fly.com

www.DarrolCady.com

www.CoolRunningUSA.com

www.TanicPacks.com
Back to top  
Coop



Joined: 02 May 2005
Posts: 26

PostPosted: Sat Jan 07, 2006 3:25 pm    Post subject:  

Glider how did you put that color scheme on? WOW awesome.
Back to top  
Glider_five_seven



Joined: 21 Nov 2005
Posts: 4

PostPosted: Mon Jan 16, 2006 1:46 am    Post subject:  

Coop,

The colour scheme is done with "Solartrim" a self adhesive stick on film, each piece cut out and stuck on individually, takes a bit of time but not difficult.
Back to top  
Glider_five_seven



Joined: 21 Nov 2005
Posts: 4

PostPosted: Mon Feb 06, 2006 11:43 am    Post subject:  

Zak,

I finally got around to flying my Foame, your suggested control deflections were spot on, it flew beautifully, no adjustments required at all.

Many thanks.
Back to top  
3dbatixkid
Moderator


Joined: 15 Apr 2004
Posts: 1178
Location: Sunnyvale, CA

PostPosted: Mon Feb 06, 2006 5:19 pm    Post subject:  

Glad it all worked out! Very Happy
_________________
Zak West

www.DesertAircraft.com

www.Smart-Fly.com

www.DarrolCady.com

www.CoolRunningUSA.com

www.TanicPacks.com
Back to top  
 
   3DBatix Forum Index -> Foamies All times are GMT - 8 Hours

Powered by phpBB 2.0.6 © 2001, 2002 phpBB Group

blueGray theme by Nuttzy
Restored from the Internet Archive, 2026 · about this archive