ARCHIVED FORUM (READ-ONLY)  ·  about this archive
3DBatix Forum Index

Cutting slot for CF reinforcing in foam/depron ?
3 posts
 
   3DBatix Forum Index -> Foamies
 
Author Message
Azryl



Joined: 10 Oct 2005
Posts: 5

PostPosted: Mon Oct 10, 2005 2:38 pm    Post subject: Cutting slot for CF reinforcing in foam/depron ?  

Hello. First post

How do modellers cut the slots in foam/depron for carbonfibre rods ?

I have seen on this forum pics of using a routing tool (which I dont have)

I would like hints or tips doing these slots with simple tools (knife, metal ruler) especially the wings etc

Thanx in advance
Azyrl
Back to top  
george



Joined: 07 Oct 2005
Posts: 2

PostPosted: Mon Oct 10, 2005 6:56 pm    Post subject:  

I have used a razor blade taped off with just a small part of the tip showing (about 1/8 in) and used a straight edge to guide it and make my cut. I make two cuts about 1/4 inch apart at an angle. Don't go all the way through. I then remove the foam that was cut. You would have a V grove cut out. I run the carbon rod in the grove back and forth a few times to get the fit I need. After you're satified with the fit you can glue the spar in place.
Hope I explained it good enough.
Good luck.
George

_________________
Wide body
Back to top  
Radioflyer



Joined: 14 Sep 2004
Posts: 325
Location: Kalamazoo, MI

PostPosted: Tue Oct 11, 2005 5:56 pm    Post subject:  

I'd go out and get a roto tool myself. It makes it a peice of cake to grove for the spare and cut bevels for the control surfaces. My dremel is priceless to me in modeling big grin
_________________
God bless us all, and keep us safe.


www.bryanhusk.com/jay
Back to top  
 
   3DBatix Forum Index -> Foamies All times are GMT - 8 Hours

Powered by phpBB 2.0.6 © 2001, 2002 phpBB Group

blueGray theme by Nuttzy
Restored from the Internet Archive, 2026 · about this archive