ARCHIVED FORUM (READ-ONLY)  ·  about this archive
3DBatix Forum Index

What do the little arrows mean in the plans?
7 posts
 
   3DBatix Forum Index -> Foamies
 
Author Message
CptanPanic



Joined: 28 May 2005
Posts: 4

PostPosted: Sat May 28, 2005 11:19 am    Post subject: What do the little arrows mean in the plans?  

I am going to build the Extra, but was wondering what the little arrows mean, for example between the two parts of the fuse. Are these the spots where you should put glue?
Thanks,
CP
Back to top  
JR.Master



Joined: 07 Nov 2004
Posts: 462
Location: San Angelo

PostPosted: Sat May 28, 2005 1:31 pm    Post subject:  

show me a pic of what it looks like. Very Happy
_________________
Did I do that? Hummmmmm!Yep, sure did!
Back to top  
CptanPanic



Joined: 28 May 2005
Posts: 4

PostPosted: Sat May 28, 2005 3:43 pm    Post subject:  

Here,
There are eight little triangle arrows in this pic.



Untitled-1.jpg
 Description:
 Filesize:  10.49 KB
 Viewed:  222 Time(s)

Untitled-1.jpg


Back to top  
Butthead



Joined: 08 Oct 2004
Posts: 1046
Location: Belvidere, NJ

PostPosted: Sat May 28, 2005 4:32 pm    Post subject:  

those arrows are pointing to the cut line. the arrow will be INSIDE the plane. in other words, where the arrows are, the objective part will be cut out.
_________________
John Paragallo

WildHare RC Extra 330LX 36%/ZDZ 120

Hangar-9 Extra 260 27%/ZDZ 50

Futaba 9C
Back to top  
CptanPanic



Joined: 28 May 2005
Posts: 4

PostPosted: Sat May 28, 2005 6:26 pm    Post subject:  

Ok Thanks,
CP
Back to top  
GUE



Joined: 14 Aug 2004
Posts: 43
Location: Moedling, AUSTRIA

PostPosted: Sun May 29, 2005 11:09 am    Post subject:  

yes but only if u build it full 6 mm depron wink
_________________
cu

GUE
Back to top  
Meyrick
Site Admin


Joined: 15 Apr 2004
Posts: 1312
Location: Fremont, CA

PostPosted: Sun May 29, 2005 10:18 pm    Post subject:  

The plan was designed to use either a 3mm or a 6mm depron for the horizontal section of the fuse. The arrows are just symbols where to cut. You cut where the dashed lines are if you want to use a 6mm horizontal section of the fuse.
_________________
--Meyrick--
Back to top  
 
   3DBatix Forum Index -> Foamies All times are GMT - 8 Hours

Powered by phpBB 2.0.6 © 2001, 2002 phpBB Group

blueGray theme by Nuttzy
Restored from the Internet Archive, 2026 · about this archive