ARCHIVED FORUM (READ-ONLY)  ·  about this archive
3DBatix Forum Index

knife edge problems?
3 posts
 
   3DBatix Forum Index -> Foamies
 
Author Message
Batix Kid



Joined: 07 Apr 2005
Posts: 76

PostPosted: Thu Apr 14, 2005 10:48 am    Post subject: knife edge problems?  

hi i have prototype foamtana that i made myself,it can pull off any 3d maneuver there is.
But it just cant hold in a knife edge at all,but when i do it seems to try and climb away or stall,unlike in the videos on the site where you manage to almost get it to stop.My cg is about 1/3 from the leading edge,it weighs just over 6 ozs.CAN ANY1 HELP?
Back to top  
Butthead



Joined: 08 Oct 2004
Posts: 1046
Location: Belvidere, NJ

PostPosted: Thu Apr 14, 2005 6:05 pm    Post subject:  

wow, 6 oz.??!! thats crazy for the Foamtana. your problem is probably too much rudder. with lee's designs you really dont need a lot of rudder. start at a higher speed and give a small amount of rudder. if this is not the problem then the only other thing i can think of is to start in a hover and let the plane fall off slightly to one side and enter a high alpha knife edge.
_________________
John Paragallo

WildHare RC Extra 330LX 36%/ZDZ 120

Hangar-9 Extra 260 27%/ZDZ 50

Futaba 9C
Back to top  
Batix Kid



Joined: 07 Apr 2005
Posts: 76

PostPosted: Fri Apr 15, 2005 6:58 am    Post subject:  

ok thanks
ill have a go laughing
Back to top  
 
   3DBatix Forum Index -> Foamies All times are GMT - 8 Hours

Powered by phpBB 2.0.6 © 2001, 2002 phpBB Group

blueGray theme by Nuttzy
Restored from the Internet Archive, 2026 · about this archive